Expansion Slot
Cover Screw
Bracket
32-bit PCI
Expansion Slots
64-bit Expansion Slots
Figure 2-3. Inserting the HP NetRAID-4M in a PCI Expansion Slot
Note:
When removing the HP NetRAID-4M, always
replace the expansion slot bracket in the empty slot to
ensure proper airflow.
Connecting the LED Activity Indicator to the
HP NetRAID-4M
An LED on the front panel of most computers lights to indicate non-
SCSI hard disk activity. If you would like that LED to light whenever
there is activity on the HP NetRAID-4M instead, you must
disconnect the LED cable from the motherboard and connect it to
the LED connector on the HP NetRAID-4M, as shown in Figure 2-4.
If the LED has a 2-pin cable and you would like to show activity on
Installing the Hardware
Card Support
Guide
Bus Contacts
2-5