System Requirements - HP D7171A - NetServer - LPr Installation Manual

Hewlett-Packard NetRAID-4M Controller Installation Guide
Tools and Capabilities
Display file system type
Detect when the file system
can be extended
Create, remove, or extend the
file system
Detect when a container is a
system or boot partition
Synchronizes display between
GUI and DM
1
The disk always gets a signature to avoid NT disk administrator pop-ups.

System Requirements

The following are the minimum system requirements for the
HP NetRAID-4M:
A 75 MHz Pentium computer that complies with PCI Rev. 2.1
or greater. If the Motherboard has bridged slots, then the
bridge needs to be PCI Rev. 2.1 or greater compliant.
A minimum of 64 MBytes of main memory.
An available full length, either 32- or 64-bit 33 MHz,
unobstructed 5-volt or 3.3-volt PCI slot that supports bus
mastering and 5v power signalling.
One 64 MByte EDO DRAM DIMM (Dual-In Line Memory
Module) with ECC for cache memory (included with
controller).
32 MBytes of available hard disk space for the HP NetRAID-
4M software.
One of the following:
– Windows NT 4.0 Server, Small Business Server Edition.
– Windows NT 4.0 Server, Terminal Server Edition.
– Windows NT 4.0 Server, Enterprise Server Edition.
– Windows NT 4.0 Server, BackOffice Edition.
– Windows NT 4.0 Workstation (for installing the controller's
GUI).
1-4
BIOS CLI
No Yes
No Yes
No Yes
Yes (boot Yes
only)
No No
GUI
Yes
No
No
Yes
No