HP D7171A - NetServer - LPr Installation Manual page 85

Chapter 7
13. Align the additional processor over the secondary slot so that the heat sink
faces towards the center of the enclosure like the processor already
installed.
14. Gently push down on the additional processor until the blue latches return
to their closed position.
15. Align the VRM card with the secondary VRM slot. Note that the
component side should face away from the VRM already installed.
CAUTION
Hold the VRM by its edges to avoid touching the components
as you push the VRM card down into the slot.
Installing Additional Processors
Figure 7-6. Install Processor
77