Configuring The Network Settings [Network]; Configure The Network Settings [Network] - Panasonic WV-SC384 Operating Instructions Manual

Configuring the network settings [Network]

The network settings and the settings relating to DDNS (Dynamic DNS) and SNMP (Simple Network management
Protocol) can be configured on the "Network" page.
The "Network" page has 4 tabs; the [Network] tab, the [DDNS] tab, the [SNMP] tab and the [FTP img. trans.] tab.

Configure the network settings [Network]

Click the [Network] tab on the "Network" page. (☞ Pages 26 and 27: How to display/operate the setup menu)
The following information is required to configure the network settings.
Contact the network administrator or your Internet service provider.
• IP address
• Subnet mask
• Default gateway (when using the gateway server/router)
• HTTP port
• Primary DNS address, Secondary DNS address (when using DNS)
■ IPv4 network
[Network Settings]
Select the method of how to configure the IP address
from the following.
Static: The IP address is configured by entering manu-
ally on "IP address(IPv4)".
DHCP: The IP address is configured using the DHCP
function.
Auto: The IP address is configured using the DHCP
function. When the DHCP server is not found, the IP
address is automatically configured.
Configure the DHCP server not to assign the same IP
addresses used for the other network cameras and PCs
whose IP address is unique. Refer to the network
administrator for further information about the settings
of the server.
Default: Static
Note:
• When "Auto" is selected and the IP address cannot
be obtained from the DHCP server, an IP address
not used in the same network will be searched
within 169.254.1.0 - 169.254.254.255.
[IP address(IPv4)]
When not using the DHCP function, enter the IP
address of the camera. Do not enter an IP address
already in use (for the PCs and the other network cam-
eras).
Default: 192.168.0.10
93