Configure The Settings Relating To Audio [Audio] - Panasonic WV-SC384 Operating Instructions Manual

[Zoom] buttons, [Focus] buttons, [Brightness] but-
tons, Control pad/buttons and [Go] button
Refer to pages 9 and 11 for descriptions of how to
operate these buttons/pad.

Configure the settings relating to audio [Audio]

Click the [Audio] tab on the "Image/Audio" page. (☞ Pages 26 and 27: How to display/operate the setup menu)
The settings relating to audio can be configured on this page.
Note:
• Images and audio will not be synchronized. Therefore, images and audio may not always match.
• Audio may be interrupted depending on the network environment.
[Audio transmission/reception]
Select the communication mode used for audio data
transmission/reception between the camera and the PC
from the following.
Off: Does not receive/transmit audio between the cam-
era and the PC. Therefore, the settings and controls
relating to audio will be invalidated.
Mic input: The PC receives audio data from the cam-
era. Audio can be heard with images on the PC.
Images and audio will not be synchronized.
Audio output: Audio data from the PC will be transmit-
ted to the camera. Audio can be heard from the
speaker connected to the camera.
Interactive(Half-duplex): Both reception and transmis-
sion are available. However, audio data cannot
simultaneously be transmitted and received.
Interactive(Full-duplex): Both reception and transmis-
sion are simultaneously available.
Default: Off
[Close] button
Click this button to close the "Privacy zone" setup
menu.
Note:
• Howling may be generated depending on usage
conditions. If howling is generated, prevent sound
generated by the PC from entering the PC micro-
phone.
• When "Multicast" is selected for "Transmission
type" on the [JPEG/H.264] (or [JPEG/MPEG-4]) tab
of the "Image/Audio" page, audio transmission will
become unavailable while monitoring H.264 (or
MPEG-4) images. To transmit audio from a PC to
the camera, click the [JPEG] button on the "Live"
page.
[Audio encoding format]
Select the audio encoding format from G.726 and
G.711.
Default: G.726
Note:
• i-PRO Series does not support aspect ratio of
"G.711". (As of October, 2010)
• G. 711 is available only when "Mic input" is selected
for "Audio transmission/reception".
[Audio bit rate]
Select "16kbps" or "32kbps" for the audio bit rate used
to transmit/receive audio data.
Default: 32kbps
Note:
• When selecting a smaller value for "Bandwidth
control(bit rate)" (☞ page 97) while putting a priority
on the JPEG/H.264(MPEG-4) image transmission,
select "16kbps" for "Audio bit rate".
72 72