Replacing A Battery - HP D5970A - NetServer - LCII User Manual

Chapter 12

Replacing a Battery

If your HP Netserver repeatedly loses its configuration or the processor clock
stops, you should replace the battery.
WARNING
There is danger of explosion if the battery is incorrectly
installed. For your safety, never attempt to recharge,
disassemble, or burn the old battery. Replace only with the
same or equivalent type recommended by the manufacturer.
Dispose of used batteries according to the manufacturer's
instructions.
1. Power down the HP Netserver and unplug power cord.
2. Extend the Netserver out from the rack.
3. Remove the Netserver cover and the air flow guide. Refer to
Chapter 2, "Opening and Closing the HP Netserver."
4. Remove the PCI card cage. Refer to Chapter 2.
5. Insert a small flatblade screwdriver or similar tool between the battery and
spring latch. See Figure 12-3.
6. Push the spring latch away from battery to release the battery and then remove
the battery.
Troubleshooting
113