HP D5970A - NetServer - LCII Configuration Manual page 118

Chapter 11
Can't unload raidserv.nlm
If an integrated HP NetRAID controller (or HP NetRAID Series adapter) in a
NetWare server is being accessed by a configuration utility (HP NetRAID
Assistant in Full Access mode or HP NetRAID Config), the raidserv.nlm
module cannot be unloaded until the controller or adapter is no longer being
accessed. This prevents a critical operation in the controller or adapter, such as a
disk rebuild, from being interrupted.
HP NetRAID Assistant does not list any servers when started (other than "local")
When HP NetRAID Assistant starts, the Main Screen only lists
"<clientname>(Local)" in the pull-down list of servers. The Registration Server
may be down, or no servers may have checked in with it.
Be sure that the Registration Server is working and that it started before the other
servers. Servers can only log into the Registration Server when the access server
(NT) or raidserv.nlm (NetWare) executes.
112
Troubleshooting