HP D5970A - NetServer - LCII Installation Manual page 65

Chapter 6
PCI Board
Bracket
I/O Panel
Figure 6-5. Replacing the Hot-Plug Board Bracket
CAUTION The lower end of the Hot Plug board bracket should press
firmly against a switch on the I/O baseboard. This switch
controls power to the slot in question. If the bracket does not
press firmly on the switch, power may not be available in
this slot when the server boots.
11. If the board you added must be cabled to the system board or chassis,
make sure that the cable is properly attached. Refer to the board
documentation.
12. Close the top cover. (See Chapter 3.)
13. If you have finished working with the chassis, slide it back and lock it in
place. (See Chapter 3.)
Installing Additional Boards
Captive
Hot-Plug
Screw
Board
Bracket
57