Step 1: Attaching Rack Nuts To The Rack - HP D5970A - NetServer - LCII Installation Manual

Chapter 13
4 Rack Nut Screws (M5 x 16mm)
8 Screws for Slides (8-32 x ¼ inch)
1 Template

Step 1: Attaching Rack Nuts to the Rack

CAUTION
If other rack components are to be mounted in the rack below
the HP NetServer, install those components before starting to
mount the server.
NOTE Use the HP Rack Assistant software to determine where in the
rack to mount the HP NetServer.
In this step, you attach rack nuts to the front columns of the HP Systems rack.
A cardboard rack-mounting template comes with the HP NetServer. This
template shows you where to mount the nuts on the rack.
1. Find the rack-mounting template for the HP Systems rack. If your HP
NetServer is still in its box, the template should be in the accessories tray
that sits on top of the server itself.
2. Hold the template alongside the outside face (the front) of one of the front
rack columns. Line up the template with the same rack space that the
server will occupy. (The template covers an area 7 EIA units high, the
same height the server requires.)
118
Alternative Rack Mounting