Installation; Installation Location - Miele KWT 2662 ViS Operating And Installation Instructions

Installation

Installation location

This appliance should be installed in a
dry, well-ventilated room.
When deciding on the installation
location, please bear in mind that the
energy consumption increases if the
wine conditioning unit is installed near a
heater, a cooker or another appliance
that gives off heat. Direct sunlight
should also be avoided.
The higher the room temperature, the
longer the compressor runs and the
higher the energy consumption of the
wine conditioning unit is.
When installing the wine conditioning
unit, please note the following:
- The mains socket must not be
located directly behind the appliance
and should be easily accessible.
- The plug and mains connection cable
must not touch the rear of the wine
conditioning unit as they could be
damaged by vibrations from the
appliance.
- Other appliances should not be
plugged into a socket located directly
behind this wine conditioning unit.
- Do not locate multiple portable
socket-outlets or portable power
supplies at the rear of the appliance.
- When positioning the appliance,
ensure the mains connection cable is
not trapped or damaged.
16
If installation near a heat source is
unavoidable, observe the following
minimum distances between the
appliance and the heat source:
- at least 3 cm
to electric or gas stoves
- at least 30 cm
to oil or coal stoves.
If it is not possible to observe these
minimum distances, an isolation plate
must be installed between the wine
conditioning unit and the heat source.