Motorola iDEN i930 Field Service Manual page 53

BASIC LEVEL TEST MODES AND PROCEDURES: Test Mode Test Procedures
f. Press Back to return to the Unit Info display, and then scroll down to highlight the
Software choice.
g. Press Select to view the current software version programmed in the unit, as well as the
software type (RSS model) and build date.
3. Press Back twice to return to the Trace Mode display.
4. Scroll down to highlight Total Usage, and then press View to view the Total Usage display.
This screen displays the number of minutes the unit has used a traffic (dispatch and
interconnect) or a Packet Data channel since manufacture.
5. Press Back to return to the Trace Mode display.
6. Scroll down to highlight System Status, and then press OK to view the System Status display.
The first line displays the SQE and Band (outbound signal quality and frequency band). The
second line displays the Carrier. The third line displays the Outbound Signal Quality. The fourth
line displays current temperature, the difference between the current temperature and the
temperature two seconds ago and the amount of cutback. The fifth line is the AGC Level and
the sixth line is the channel code.
7. Press Back to return to the Trace Mode display.
8. Scroll down to highlight N6: Intrcnct, then press OK to view parameter details related to
RF-originated messages.
9. Press Back to return to the Trace Mode display.
10. Scroll down to N6: Dispatch, then press OK to view the newest dispatch data.
11. Press Back to return to the Trace Mode display.
12. Scroll down to highlight GPS, and then press View to view the GPS display.
a. Location selection displays the number of satellites used to obtain the position fix, the
current cell site latitude and longitude, the subscriber unit latitude and altitude information,
as well as the last calculated horizontal and vertical accuracy.
b. Time Info selection contains iDEN time information used to determine accurate GPS time.
c. Assist selection contains the subscriber unit latitude, longitude and horizontal accuracy in
meters as well as an indication of whether the data is valid or not.
d. Navigation selection contains the heading as well as velocity and velocity error in
kilometers/hour.
e. Summary selection contains time and longitude/latitude expressed in degrees. Accuracy in
meters is also displayed.
f. GPS Version contains information about the custom Sirf software used in the unit.
13. Press Back to return to the Trace Mode display.
6-6
68P80401P03-O