Main Output; Additional Features - HP 8112A Operating, Programming And Servicing Manual

Main Output

Additional Features

Non-Volatile Memory
Self-test
Error detection
HP-IB Capability
Capability codes
Learn modes
Service request
2-6 Specifications
External voltage limits
Amplitude
Reflections
Source Impedance
Short circuit capability
External voltage limits
Set
Sets up square wave, delay min. LEE, TRE=lO% PER or fixed
Power down location
9 programmable locations
Standard settings location
The instrument performs a self-test when switched on, and by HP-IB
command.
Visual and Status Byte indication of incompatible settings,
under-range control voltage, and clipped amplitude (excessive
transition time).
The HP 8112A is fully programmable except for the External Input
trigger level.
All or individual parameters can be programmmed and uploaded
Initiated by syntax and operating errors, returns error number
-0 v, +5 v
100 mV to 16 V (200 mV to 32 V) pp
< 10%
50 3-l
Maximum peak current 150 mA
for up to 1 hour (15°C to 35°C)
saves current settings
a
each stores complete setup
100 /.Ls, 1 V pulse at 1 kHz