Bosch 1617 Operating/Safety Instructions Manual page 20

EDGEFORMING DUST
EXTRACTION HOOD
Do not reach in area of the
bit while the router is ON
or plugged in. To avoid entangling hoses,
do not use this dust extraction hood at
the same time as any other dust
extraction hood.
This dust extraction hood (optional
accessory) is used for dust collection when
edge-forming (Fig. 24).
ATTACHING DUST EXTRACTION HOOD
You can attach the edge-forming hood in
several places according to your needs or
preferences. This hood is attached using two
of the screw holes on the router base that
are used to attach the router's sub-base.
Choose the desired location for the hood.
Loosen and take out the two screws from the
router base and attach the dust extraction
hood -- over the router's sub-base -- using
the screws provided with the hood. Securely
tighten the screws. (Figures 25 & 26).
WORKPIECE
EDGE
DUST
EXTRACTION
HOOD
ROUTER
SUB-BASE
M4x16mm
SCREW
M4x16mm ", .
SCREW "', ""
M4 x16ram
SCREW
DUST
EXTRACTION
HOOD
DUST
HOOD
M4x16mm
SCREW
-20-