Bosch 1617 Operating/Safety Instructions Manual page 11

,,To position switch on the left, line up the
base's arrow with arrow on the motor
housing that is below the switch.
3. Slide motor into base until resistance in
felt. (The base's guide pin is now engaged
into slot on motor.)
4. Turn the motor clockwise until it stops.
5. Push the motor into the base as far as it
will go.
6. Fasten the base clamp lever.
INSTALLING TEMPLET GUIDE ADAPTER
Place templet guide adapter over the holes in
the center of the sub-base, and align the two
threaded holes in the bottom of adapter with
the countersunk holes in sub-base. Fasten
adapter with the screws provided. Note that
the adapter is reversible, so the release lever
may be positioned as desired. (Fig. 9)
IIi[_.'1
TEMPLETGUIDE
ADAPTER
,_ _,-- MOUNTINGSCREWS
CHIP DEFLECTOR
_ lways wear eye
protection. The chip
deflector is not intended as a safety
guard.
The chip deflectors help keep dust and chips
out of your face, it will not stop objects larger
than dust thrown from the bit.
To remove chip shield from bases, press
inward on tabs until it releases from base and
remove. To attach, place deflector into
position as shown in (Fig. 10). Then flex
sides of deflector while pushing until it snaps
into place. The plunge base's chip shield can
also be flipped out.
-11-