Wired Remote Controller Installation - Hitachi airCore 700 Installation & Maintenance Manual

5.2 Wired Remote Controller Installation

The Wired Remote Controller model compatible with the Zone Interface Box is PC-ARFG2-Z. For
detailed installation, please see steps below.
[Before Installation]
(1) This packing contains the following parts.
Name
Appearance
Qty.
(2) When installing two controllers one above the other, allow a gap of at least
50mm between the two.
[Installation Procedures]
(1) Insert the edge of the slotted screwdriver into the groove at the bottom of the holding bracket, push and turn
the slotted screwdriver to separate and remove the controller from the mounting plate.
Groove Part
NOTE:
•
Do not insert the slotted screwdriver into the tab beside the groove. The tab may be damaged and the
advanced color wired remote controller cannot be installed.
PC-ARFG2-Z
Operation Manual
1
Tabs for Attaching Controller
INSTALLATION & MAINTENANCE MANUAL
Installation & Maintenance
Manual
1 1
Approx. 6mm
Slotted
Screwdriver
Figure Seen from Bottom Side
Mounting Plate
11
Screw
M4 × 16mm
2
more than 50mm