Advertisement
USING THE TIME COUNTER
TO MONITOR THE ELAPSED PLAYING TIME
Generally, the time counter shows
the elapsed playing time from
the beginning of the selection in minutes and seconds.
When a new selection starts, the counter is reset to "0.00" and then
starts counting time again.
If the selection has a blank space at its beginning, the counter is
reset to the time preceded
by the minus
sign such
as '"~0.02",
"-0.01", etc.
TRACK number
Minutes
Seconds
lame
-I
fo
=I,
|
shows 15 minutes 30 seconds has elapsed from the beginning of the third
selection
TO MONITOR THE REMAINING PLAYING TIME
When
the LAP/REMAINING
TIME
button
is pressed, the counter
shows
the remaining time, preceded
by a minus
sign, before the
end of the last selection.
ee .
DISC SET
TRACK NO
SECOND
shows 30 minutes 00 seconds remaining before
the end of the disc
The digits will change, for example, from —30.00 to —29.59, —29.58...
as the play goes on, and you can
monitor the remaining
playing
time at any point of the disc.
To return the counter to the elapsed time, press the LAP/REMAIN-
ING TIME button again.
When
the RESET or OPEN/CLOSE
button
is pressed, the counter
will also return to an elapsed time indication.
Note:
When
the ke@ or B&! button
is pressed, the counter will
show the track number of the selection for a few seconds.
CDP-101
TIMER-ACTIVATED PLAY
Power connection
ee —————
OE
EEE
to a wall outlet
t
- Amplifier
CDP-101
To play using a timer
1 Set the player's TIMER PLAY switch to OFF.
2 Turn on the amplifier and set the appropriate switches for disk
playing.
;
3 Turn on the player and insert a disc.
4 Set the timer for the desired time.
(At this point, power will be cut off.)
5 Set the player's TIMER PLAY switch to ON.
The player is now
ready to start play of the first selection at the
time set on the timer.
After the timer-activated play has been completed...
Be sure to set the TIMER PLAY switch of the CDP-101 to OFF.
Advertisement
