Advertisement
, Installation
1 Remove the rear cover of the monitor.
2 Remove the G board once and attach it
again as the illustration. —
"Remove 10 screws -
3 Pull out the connector panel.
4 '(for only 2iHnchi monitors)
;
:
install
the supplied adaptor fitting for 20-
inch monitors.
ee
.
- © Adaptor fitting for-
20-inch monitors
cao Supplied screw
(4BVTT 4 x 8)
3
5 instail BKM-102 (BA beard) in the SDI
| If you install only the BKM-101C, go ta step 6. |
Continue:
. @ Insert the 30-pin flat cable connector.
inte the CN5 terminal on the BV hoard,
"and Secure the BA board using the
supplied 4 screws -with BKM-102.
a
&
module of BKM-101C.
© Remove the cover of the SO! module
and connect the supplied connecting
© Insert the BA board into the SDI
Es
module.
Sis
:
:
ae
:
© Connect the CN1 terminal on the BA -
board te the CN3 teminal on the B -
Use the 30-pin flat
board, and connect the CN2Z terminal on
cablewiththe
the BA board to the CN4 terminal on
"metal side fading
:
the BV bvard, using the connecting
cables supplied with BKM-102.
Re
CN2
4-pin
Pp
connect:
cable
~
5-pin
connecting
'cable
© Position the connecting cables to the
side of the boaril, ge
ats
o Attach the cover of the SDI modute
4
ising the 8 screws removed in step @.
5
Advertisement
