Advertisement
=P
Installation
7 install the SDI module in the monitor.
oy
@ Remove the cable clamp from the
monitor and then the monitor cabie.
@ Attach the suppiied holders (white).
© Fasten the:2-cables from the SD}
module with the attacked holders from
i+) Fasten-the thonitor cable (connected ta
the CN401 terminal) and the cable from —
the SDI module (connected to the CN&
terminal on the BB hoard) with the
supplied.cable clamp (back). -
Kony
«Pull the SDIl' module
- — ~
back {to the connector
side), and fasten it with
* screws.
*
@ Fasten the 2 cables from the. SDI
moduie to the monitor with the:
installed cable clamps.
© Fasten the monitor cable {connected to
the CN401 terminal) and thé cable from
the-SDI module (connected to the CNS
terminal on the 8B board} with the
supplied. cable clamp {btack).
Push the SDI module forwards
{to the display'side),
a n d .
fasten it with screws, ©
Centinue
& fasten the cable connected te the CN607
terminal on the power board.
Make sure that the cable does not loosen, and
faster it with the cable clamps installed on
PVM-20¥42U ~
PVM-20M2E
the moniter.
PYM-20M4U
PVM-20M4E
:
PYM-20M44,
PVM-14M2U
PYM-14M2E
PYM-14M4U-< "1. PVM-14Mi4E
PYM-14M4B.. 1
PVM-14M2A
* PVM-14M4A.
9 instalt the-c board.(removed In step 2) as
itwas.
a:
,
Advertisement
