Advertisement
7° install the SDI module in the moni
installation
@ Remove the cable clamp from the
monitor and then the monitor cahle."
© Attach the suppiied holders (white).
@ Fasten-the 2 cables from the SDI
modulé with the attached holders from
© Fasten the moniter cable {connected to
the CN4C1 terminal) and the cable from
the SDI module (connected to the CNS
terminal on the BB board) with
t h e
Pull the SDI medula
back (to the
comnertor sides, and
fasten it with screws.
_ @ Fasten the2 cables from the SDI
_+, module to the monitor with the
'installed cable.ctamps: ©"
-. @ Fasten the monitor cable (connected to
the CN401 terminal) and the cable from
the $DI module {connected to the CNS
- terminal on the BB board) with the
-Supplied-cable clamp {black). |
.Push the SDI module
forwards {ta the display side),
and fasten it with screws.
§ :Fasten the cable (connected to the CN304
termlnal} to the monitor with the installed
cable clamps.
9g Instail the G board (removed In step 2) as
12 (or only 14-inch monitors)
Hold the cabies {removed in @ from step
7) of the monitor using the cable clamp of
the $D1 module.
,
:
module on the rear caver of the monitor,
and stick the conmerctor labed beside the
* holes.
Make holes
oO
with nippers
14 Replace the rear cover of the monitor
'
using the 10 screws removed in step 1 so
that the SDI-connectors expose from the
rear cover, and fix them with the supplied
rew
(silver} x 6
> Supplied screws
(#BVIT 4x 8)
9
Advertisement
