Table of Contents
Advertisement
2 CAPSTAN (capstan lock) setting
Set the capstan servo lock mode.
2F: Lock the capstan servo on 2
fields. When performing picture
shift under the 525 system, set
setup menu item 712 to ON (see
page 6-27).
4F: Lock the capstan servo on 4
fields.
8F: Lock the capstan servo on 8
fields (625 system only).
3 DF/NDF setting (in 525 mode)
Select DF to advance timecode in
drop-frame mode, and NDF to
4 BACKLGT (back light) setting
Set to HIGH to increase the brightness
of the LCD monitor back light.
5 KEY INH (key inhibit) setting
Set to ON to disable the buttons on the
control panel. (Sub LCD menu
operations can still be performed even
when this item is set to ON.)
You can select the buttons that are
disabled under setup menu item 118
(see page 6-12).
If you try to operate the disabled
buttons, the message "!!KEY INH.!"
appears in the time data display area
on the sub LCD.
6 BAT-END (battery end) setting
Set a voltage value to indicate the
shutdown voltage of this unit
depending on the batteries you are
using.
7 BAT-NE (battery near end)
setting
For alarms that alert you when the end
of power as specified in the battery
end setting 6 is near, specify a
voltage that at which to begin the
alarm display.
8 LIGHTSW (backlight control
switch) setting
Controls back light power of the LCD
monitor and sub LCD.
SUBMAIN: The both are controlled
by the LIGHT switch.
MAIN: The LCD monitor back light
power is controlled by the
LIGHT switch. The sub LCD
back light power is continually
on.
SUB: The sub LCD back light power
is controlled by the LIGHT
switch. The LCD monitor back
light power is continually on.
2-33
Preparations
Advertisement
Table of Contents
