Bosch MUM9BX5S22 Instruction Manual page 14

en Parts and operating controls
Display
X Fig. A
Settings, information, error messages and
values are indicated on the display. Here,
long texts will run from right to left in order
to display them fully.
Example:
YEAST DOU
HOLD ROTARY S
AST DOUGH
ON M/A FOR 2s
The language in which the text is displayed
can be changed. X "Settings" see
page 16
Function buttons
X Fig. A
The appliance has 3 to 5 function buttons
(depending on the model), using which
special additional functions and automatic
programmes can be selected and adjusted.
Buttons
SensorControl Plus /
D*
Programme selection / Back
A*
Timer / Selection / Back
C*
Scales / Tare / Back
-
Reduce selection/values
+
Increase selection/values
* Depending on the model
Function selection buttons D / A / C
Briefly pressing them will activate the
function selected. Press and hold to leave
the selected function. "OptiMUM" will
appear on the display again.
14
GH
WITCH ON
Note: The buttons are operated by gently
touching them with your finger. Wearing
kitchen gloves may impair the function of
the buttons. It is not possible to operate
buttons with objects (e.g. wooden spoon).
Rotary switch with
illuminated ring
X Fig. B
The rotary switch is used to select the
required speed, start an automatic
programme or to switch the appliance
off. The integrated illuminated ring lights
up during operation. The appliance will
no longer switch on if there is an error in
appliance operation, if the electronic fuses
trip or the appliance has a defect, and the
illuminated ring will light up.
Settings
ü The setting ü has two different
functions:
Standard (M):
Instantaneous switching
at maximum speed/fast. Hold
down rotary switch for the required
duration.
With SensorControl Plus (A):
Automatic regulation of the duration.
After activating the automatic setting,
set the rotary switch to ü and hold
in this position for a few seconds.
The rotary switch will remain set
to ü and will revert back to y
after the automatic programme has
ended. The appliance is switched off.
X "Using SensorControl Plus" see
page 19
Stop / Switch off
y
Function "Folding in" at
z
minimum speed / very slow
1...7 Speed settings
1: low speed / slow
7: maximum speed / fast