D-Link DSL-2750U User Manual page 98

DSL-2750U Wireless ADSL2+ Router with 3G/LTE/Ethernet WAN Support
and USB Port
User Manual
Parameter
Direction
Only for the values Ethertype, MAC, and IP of the Type filter drop-down list.
State
Title
Value
Select one of the ports to traffic from which the rule will be applied
or select the All LAN interfaces value to apply the rule to traffic
passing through all the router's ports.
The direction of the traffic.
Traffic Selection
To specify a filtering parameter for the rule, select the checkbox
located in the line corresponding to this parameter. If the checkbox
is selected, the Value field is available for editing.
A name of a filtering parameter.
Specify parameters available for the relevant filter type.
For the Ethertype type
Source MAC: The MAC address of a device from the router's
LAN.
EtherType: Select a protocol to which the rule will be applied from
the drop-down list.
For the MAC type
Source network: The source host/subnet IPv4 address.
Source port: A port of the source IPv4 address.
Source MAC: The MAC address of a device from the router's
LAN.
For the IP type
Destination network: The destination host/subnet IPv4 address.
Source network: The source host/subnet IPv4 address.
Protocol: Select a protocol to which the rule will be applied from
the drop-down list.
Destination port: A port of the destination IPv4 address. You can
specify one port or a range of ports separated by a colon. If you use
this parameter, select a protocol from the Protocol drop-down list.
Source port: A port of the source IPv4 address. You can specify
one port or a range of ports separated by a colon. If you use this
parameter, select a protocol from the Protocol drop-down list.
Page 98 of 181
Configuring via Web-based Interface
Description