Bosch F.01U.299.030 Operation Manual page 48

48 en | Configuration
–
–
Notice!
Ensure that the Bosch ONVIF Camera has firmware 5.80 or higher.
ONVIF cameras
ONVIF cameras are automatically detected, but you still need to:
1.
2.
Panasonic and Sony cameras
The system supports Sony IP cameras via CGI commands for 300/360 series, and Panasonic IP
cameras via CGI protocol (HD Integrated Camera Interface Specifications 1.06).
Panasonic and Sony cameras are not automatically detected. You need to:
1.
2.
3.
4.
5.
Until the camera is properly connected, a trash can is displayed next to the Camera name
allowing you to delete the camera.
Once the camera is connected (the URL, Username, Password and Protocol fields are all
correct) you can browse to a specific camera using the link in the Serial number.
Note: Only a disconnected camera can be removed.
Notice!
You can use the Camera name to assign a logical name to the camera, e.g. right rear camera.
Network and general settings
Click the Network and general settings button to open the network and general settings
page. Here the network and general settings are displayed and can be set:
Click the Change network settings button to enter/change the network settings:
–
2020.05 | V2.2 |
– Incorrect IP address: 192.168.010.111
Recycle bin: Click the recycle bin icon to remove the selected camera. Note: Only a
disconnected camera can be removed.
Camera settings overview: Here an overview of all connected cameras is listed. The
overview list shows: the Camera name, URL, Serial number, Username, Password,
Protocol, and to which video switcher Input the camera is connected to.
– The camera Serial number is used as a link to the camera configuration web pages.
Note: Only possible if your PC/laptop or tablet device is connected via the wired
Ethernet connection of the system.
Enter a username and password if the camera has a username and password configured.
Select the switcher input the camera is connected to.
Manually add the camera using the + button.
Enter the camera URL (as http:// for a non-secure connection or https:// for a secure
connection).
Enter the username and password for the camera.
In the Protocol field, select Sony for Sony cameras, and Panasonic for Panasonic
cameras.
Select the switcher input the camera is connected to.
Network settings:
Operation manual
Digital Discussion System
Bosch Security B.V.