Connections; Connect System Components - Bosch F.01U.299.030 Operation Manual

24 en | Connections
6

Connections

This section describes the connections of:
–
–
–
6.1

Connect system components

6 2
Figure 6.1: Connecting Discussion Devices
For detailed information on the connections of the CCS 1000 D Digital Discussion System,
refer to:
–
–
–
1.
2.
3.
2020.05 | V2.2 |
the Control Unit
the Discussion Device
the Extension Unit
6 1
6 2
Control Unit connections, page 26
Extension Unit connections, page 29
Discussion Device connections, page 28
Connect the Discussion Devices (2) in a daisy‑chain configuration, using extension cables
(3) where required, to the 'Trunk' connectors at the rear of the Control Unit (1) and
optional Extension Units.
Note: The above figure only shows a small system with a Control Unit. For the maximum
number of Discussion Devices and Extension Units that can be connected to the system,
including extension cables, refer to Setup options and limits, page 17 .
Secure the system cables with cable clamps and cable locking clamps, as required.
If you want to use the web browser interface or system cameras with the CCS 1000 D
Digital Discussion System, connect an RJ45 Ethernet cable to the 'Network' connector at
the rear of the Control Unit.
Operation manual
Digital Discussion System
6 3
6 2
6 2
Bosch Security B.V.