Installation Of The Sensor Base - Bosch PLS User Manual

Parking Lot Sensor | PLS

Installation of the sensor base

The bottom of the base has been processed with a plasma treatment to improve the adhesion of the
glue on the ground:
 Take out the base of its protective wrap only just before putting down the adhesive there.
 Do not touch the bottom side of the base with your hands or anything else.
 Do not put the base on the ground before gluing, to avoid dust on the sensor base.
 Ensure that all parts of the PLS will be protected and will be kept clean until the installation has been completed, so
that these parts will be used only within the described intended use.
 Check that the adhesive is compatible with the ground and the base of the sensor.
 Ensure that sufficient adhesive is uniformly spread over the bottom side of the sensor base.
Prepare the adhesive following the manufacturer instruction.
Please note that, as soon as the two components are mixed, the adhesive cures within a few minutes.
Do not try to save adhesive by adding less adhesive per sensor base!
First, insufficient quantity of adhesive may subsequently lead the PLS to
detach from the ground and the PLS may get lost.
Second, if the adhesive is not uniformly spread-over the base, it could lead to localized
stresses and therefor to structural damages when a car runs over the product.
Once all precautions have been taken, you can proceed with the fixing of the sensor base to the ground (by applying light
pressure on it. See Fig. 8 Sensor base attachment). Make sure that the sensor base is thoroughly and uniformly fixed flat
against the ground, that the base is centered in the parking space and that the Bosch logo on the sensor base points
towards the access road (see Figure 9 Sensor base installed). Subsequent twisting of the sensor base is not possible.
Figure 8 Sensor base attachment
© Robert Bosch France SAS 2022. All rights reserved, also regarding any disposal, exploitation, reproduction, editing, distribution, as well as in the
event of application for industrial property rights. Data subject to change without notice. Printed in France, December 2022.
Precaution
Precaution
Figure 9 Sensor base installed
7 | 18