Connections - Bosch LHN-UC15L-SIP User Manual

LHN‑UC15L‑SIP | LHN‑UC15W‑SIP | AMN‑P15‑SIP
2.1.3

Connections

To access the cable connections, do the following:
1.
2.
The back of the IP Horn loudspeaker shows as the reference view bellow.
Reference view
Figure 2.2: Back panel of the IP Horn loudspeaker (without the cover)
Connecting the network (Figure 2.2, callout 1)
The IP Horn loudspeaker supports PoE/PoE+ power supply mode. You need one Ethernet
cable to connect to a PoE switch or injector for a convenient installation. For the most reliable
operation, always use shielded CAT-5e or higher class cables.
Notice!
i
Connect the IP Horn loudspeaker using shielded network cables that are properly grounded.
To connect the network cable:
1.
2.
3.
4.
4
There are two lights on the Ethernet jack:
–
–
Bosch Security Systems B.V.
Using a T20 Torx screwdriver, remove the four cover screws.
Lift the cover from the chassis with care.
1
Cut an Ethernet cable to the desired length.
Thread the Ethernet cable through the cable gland on the bottom left of the cover.
Crimp the RJ45 connector to the cable.
Connect that end of the cable to the network port (Figure 2.2, callout 1).
Verify the network connection:
The network port LED turns on a few seconds after the network cable is connected,
indicating that PoE/PoE+ power has been successfully applied.
A solid green LED (right) indicates the port is operating at 1000 Mbps (1 Gbps). It flickers
to indicate network activity.
An orange/yellow LED (left) indicates a network link of 100 Mbps. It flickers to indicate
network activity.
2 3
User manual
Installation | en
2023.02 | V01 | F.01U.389.835
9