Installation; Lhn-Uc15L-Sip Or Lhn-Uc15W-Sip Ip Horn Loudspeaker; Considerations; Mounting - Bosch LHN-UC15L-SIP User Manual

8 en | Installation
2

Installation

This chapter shows you the steps necessary to install the IP Horn loudspeaker and the IP
Amplifier module.
2.1

LHN-UC15L-SIP or LHN-UC15W-SIP IP Horn loudspeaker

2.1.1

Considerations

Before installing the IP Horn loudspeaker, consider the following:
Mounting location:
The IP Horn loudspeaker must be fixed to a stable and suitable surface to support its weight.
–
–
Required tools
–
–
2.1.2

Mounting

The IP Horn loudspeaker comes with a metal bracket attached. The mounting bracket has one
central hole and two slotted holes adjacent to it. The central hole has a diameter of 6.8 mm.
The slotted holes are 15 mm x 7 mm.
Figure 2.1: Mounting bracket
To mount the IP Horn loudspeaker unit to a wall or any other solid surface, do the following:
1.
2.
3.
4.
5.
6.
7.
2023.02 | V01 | F.01U.389.835
The mounting surface must be able to support more than the nominal weight of a single
loudspeaker.
Choose the mounting location where there is an unobstructed line-of-sight path between
the horn and the intended area of coverage.
M13 wrench (fasten torque: 5-6 Nm)
T20 Torx screwdriver (fasten torque: 1.3-1.8 Nm)
Using a M13 wrench, remove the side screws and washers that attach the bracket to the
IP Horn loudspeaker.
Remove the bracket from the IP Horn loudspeaker.
Fit the bracket in its final position and secure it with one screw in the central hole.
Rotate the bracket until you achieve the position you desire.
Affix the bracket with two screws in the remaining slotted holes.
Reattach the IP Horn loudspeaker to the bracket, inserting the side screws and washers.
Make sure the IP Horn loudspeaker is facing the ground in a 10° angle.
Fasten the side screws to lock the IP Horn loudspeaker to its final position with a torque
of 5-6 Nm.
LHN‑UC15L‑SIP | LHN‑UC15W‑SIP | AMN‑P15‑SIP
User manual
Bosch Security Systems B.V.