Mount The Hardware - Philips Smart-hopping 2.0 Installation Manual

Mount the Hardware

1
2
Smart-hopping 2.0 Access Point 1.4 GHz Installation Guide
Attach the access point to the Cosmetic
Cover using the two M3 x 0.5 x8 screws.
• Place the Access Point face down.
• Place the plastic cover over the Access
Point.
• Make sure the two holes in the plastic
cover align with the corresponding holes
in the Access Point.
• Secure the Access Point to the cosmetic
ring by screwing in the two M3 x 0.5 x8
machine screws into the holes in the
cosmetic ring and into the Access Point.
Perform this step to connect both
adapter plates to the mounting
bracket:
• Remove the adhesive strip from the
adapter plate.
• Orient the adapter plate so the bolts
face the same direction as the shoulder
screws that are already attached to the
bracket.
• Place the bolts through one set of outer
holes on the bracket.
• Press the adapter plate firmly against the
bracket to ensure a strong adhesive
hold.
DRAFT - 03 JUN 2022 13:32
Below Ceiling Mount (with Cosmetic Cover)
2-35