Philips Smart-hopping 2.0 Installation Manual page 21

Power/Sync
Flashing Red
Flashing Red
Smart-hopping 2.0 Access Point 1.4 GHz Installation Guide
LED1 -
LED2 - Network
Green Flashing Green
Amber Amber
Amber Amber
Flashing Green
Red Off
Flashing Red
Off Off
White White
Blue Blue
DRAFT - 03 JUN 2022 13:32
Connectors and Status Indicators
Table 1-2: Access Point Status LEDs
LED3 - Radio LED4
Flashing Red Off
Amber Amber
Amber Off
Flashing Green Off
Off Off
Flashing Red Off
Off Off
White White
Blue Blue
Remote Antenna Status
Power/Sync and Network are
working properly. There is an
issue with the radio.
LEDs that display during the
Access Point Initial POST (Power-
On-Self-Test)
The Access Point is not registered
to any APC.
The Access Point has lost local
synchronization. Check local
(upstream) synchronization.
If the Access Point is in this state
for more than 5 seconds, this
indicates that the Access Point
has power but has a hardware
fault in another area. Replace
the Access Point.
Hardware POST failure (there is
an issue with one or more of the
following components: DRAM,
Flash Memory, CPU, Radio, LAN
Interface)
The Access Point either does not
have power or configured to
turn the LEDs off.
310236883
2022-06-07 20:00:10
--------------------------------------------
Blue - not in service
See Specs in Windchill 867216-90002
1-9