Mount The Hardware - Philips Smart-hopping 2.0 Installation Manual

Mount the Hardware

1
2
3
Smart-hopping 2.0 Access Point 1.4 GHz Installation Guide
Perform this step to connect both
adapter plates to the mounting
bracket:
• Remove the adhesive strip from the
adapter plate.
• Orient the adapter plate so the bolts
face the same direction as the shoulder
screws that are already attached to the
bracket.
• Place the bolts through one set of outer
holes on the bracket.
• Press the adapter plate firmly against the
bracket to ensure a strong adhesive
hold.
Connect the mounting bracket to the
Access Point. Make sure the side of the
mounting bracket with the rectangular
cutout lines up with the connectors on
the back of the Access Point.
Line up the shoulder screws on the
bracket with the 4 keyholes in the
Access Point and slide the bracket
toward the connectors. You hear a
click noise when the bracket is secure
on the Access Point.
Place the Access Point assembly,
finished side down, on a flat surface
and place the Cosmetic Ring over the
Access Point assembly.
DRAFT - 03 JUN 2022 13:32
Flush Ceiling Mount (with Cosmetic Ring)
2-17