Chapter 2: Mount and Install the Smart-hopping 2.0 Access Point 1.4 GHz
5
6
7
8
2-16
Mark an X on the edge of the tile
where the Cable Access marking on the
mounting rail points. This ensures that
the mounting rail faces the correct
direction when you flip the tile to
mount the mounting rail on its
unfinished side (in a later step).
(Optional) Remove the mounting rail
from the tile and draw lines that
connect the points together.
After taking the mounting rail off of
the tile, cut out the area of the tile
between the dots you marked.The
open space is where you mount the
Access Point.
Put the tile and mounting rail aside.
DRAFT - 03 JUN 2022 13:32