Huawei FusionModule2000 Maintenance Manual page 75

FusionModule2000 Smart Modular Data Center
Maintenance Guide
Step 2 Label each cable and antenna based on the corresponding ports on the ECC800-
Pro main control module.
Step 3 Remove cables, USB flash drive, USB-to-WiFi module, and antennas from the
ECC800-Pro main control module.
Step 4 Loosen the screws on both sides of the ECC800-Pro main control module and pull
the handles on both sides of the ECC800-Pro main control module to remove the
main control module.
Figure 5-4 Removing the ECC800-Pro main control module
Step 5 (Optional) Remove the Micro SD card and SIM card from the corresponding slots
of the ECC800-Pro main control module.
Step 6 (Optional) Install the removed Micro SD and SIM card in the corresponding slot of
the new ECC800-Pro main control module.
Figure 5-5 Installing the Micro SD and SIM card
Step 7 Install the spare ECC800-Pro main control module in the ECC800-Pro subrack and
tighten the screws on both sides of the ECC800-Pro main control module.
Step 8 Connect the communications cables and antennas to the ECC800-Pro main control
module.
Step 9 Choose Maintenance > Configuration File and import the backup configuration
file, or set parameters for the devices that connect to the ECC800-Pro to ensure
normal communication.
----End
Issue 02 (2022-07-30) Copyright © Huawei Digital Power Technologies Co., Ltd.
5 Parts Replacement
68