GE AMX-4+ Technical Manual page 99

GE MEDICAL SYSTEMS
REV 5
7 2 3 Raise Front Wheels
ILLUSTRATION 7-5
AMX-4 UNIT WITH JACK IN PLACE (FRONT)
Note:
ILLUSTRATION 7-6
AMX-4 UNIT SUPPORTED BY WOOD BLOCK (FRONT)
WOOD BLOCK(S)
(SEE NOTES 1, 2, & 3)
1. Remove front bumper pads. Refer to Section 7 1 1.
2. Put the jack under the front of the AMX unit. See Illustration 7-5.
Ensure that the two lips on the front of the jack retain the front of the
base in to prevent the unit from falling off the jack.
3. Lift the AMX unit high enough to put the wood block (one 4x4 inch or two 2x4
inch) under the AMX unit as shown in Illustration 7-6. Be sure that the block(s)
is (are) centered under the front battery box wall, and be sure that the block(s)
extend(s) out at least 2 inches (5 cm) on each side of AMX unit.
2 INCHES
(5 cm) MIN.
FRONT BATTERY
BOX WALL
(MODEL 2169360, 2236420 & 2275938 SERIES)
NOTE 1: IF TWO BLOCKS ARE USED, ORIENT
NOTE 2: CENTER BLOCK(S) WITH FRONT
NOTE 3: LOCATE WOOD BLOCK(S) SO THAT
7-5
AMX-4+ SERVICE
DIRECTION 2173225-100
BLOCKS FOR MAXIMUM STABILITY.
BATTERY BOX WALL.
BLOCK(S) STICKS OUT AT LEAST 2
INCHES (5 cm) BEYOND EACH SIDE
OF THE AMX UNIT.