Mode Select Switch Inspection; Input Shaft Speed Sensor Removal And Installation; Input Shaft Speed Sensor Inspection - Suzuki Grand Vitara 2011 Manual

Mode Select Switch Inspection

1) Pull out mode select switch from front center console
box.
2) Disconnect mode select switch connector.
3) Check continuity between mode select switch
terminals.
Mode select switch specification
Mode select
Normal position Power position
switch
Continuity No continuity
A
B
A: Push
Input Shaft Speed Sensor Removal and
Installation
Removal
1) Disconnect negative cable at battery.
2) Hoist vehicle.
3) Disconnect input shaft speed sensor connector.
4) Remove input shaft speed sensor (1) from
transmission.
1
S6JB0A5106014
Continuity
I5JB0A510042-01
B: Push again to release
S6JB0A5106015
I5JB0A510043-01
Automatic Transmission/Transaxle:
Installation
1) Check that sensor is free from any metal particles
and damage.
2) Apply A/T fluid to new O-ring and then install input
shaft speed sensor (1) to transmission.
Tighten sensor bolt to specified torque.
Tightening torque
Input shaft speed sensor bolt (a): 7 N·m (0.7 kgf-
m, 5.0 lb-ft)
(a)
1
3) Connect input shaft speed sensor connector.
4) Lower hoist.
5) Connect negative cable at battery.

Input Shaft Speed Sensor Inspection

1) Disconnect negative cable at battery.
2) Hoist vehicle.
3) Disconnect input shaft speed sensor connector.
4) Check input shaft speed sensor (1) for resistance
between terminals of sensor.
Input shaft speed sensor resistance
Standard: 560 – 680 Ω (at 20 °C (68 °F))
1
5A-94
I5JB0A510044-01
S6JB0A5106016
I5JB0A510045-01