Mode Select Switch Inspection; Input Shaft Speed Sensor Removal And Installation; Input Shaft Speed Sensor Inspection - Suzuki Grand Vitara Manual

Transmission / transaxle
Hide thumbs Also See for Grand Vitara:
Table of Contents

Advertisement

5A-88 Automatic Transmission/Transaxle:

Mode Select Switch Inspection

1) Pull out mode select switch from front center console
box.
2) Disconnect mode select switch connector.
3) Check continuity between mode select switch
terminals.
Mode select switch specification
Mode select
Normal position Power position
switch
Continuity
No continuity
A
B
A: Push
Input Shaft Speed Sensor Removal and
Installation
Removal
1) Disconnect negative cable at battery.
2) Hoist vehicle.
3) Disconnect input shaft speed sensor connector.
4) Remove input shaft speed sensor (1) from
transmission.
1
S5JB0A5106053
Continuity
I5JB0A510042-01
B: Push again to release
S5JB0A5106054
I5JB0A510043-01
www.CarGarage.ir
Installation
1) Check that sensor is free from any metal particles
and damage.
2) Apply A/T fluid to new O-ring and then install input
shaft speed sensor (1) to transmission.
Tighten sensor bolt to specified torque.
Tightening torque
Input shaft speed sensor bolt (a): 7 N·m (0.7 kgf-
m, 5.0 lb-ft)
(a)
1
3) Connect input shaft speed sensor connector.
4) Lower hoist.
5) Connect negative cable at battery.

Input Shaft Speed Sensor Inspection

1) Disconnect negative cable at battery.
2) Hoist vehicle.
3) Disconnect input shaft speed sensor connector.
4) Check input shaft speed sensor (1) for resistance
between terminals of sensor.
Input shaft speed sensor resistance
Standard: 560 – 680 Ω (at 20 °C (68 °F))
1
www.CarGarage.ir
I5JB0A510044-01
S5JB0A5106055
I5JB0A510045-01

Advertisement

Table of Contents
loading

Table of Contents