P/S Pump And A/C Compressor (If Equipped) Drive Belt Removal And Installation (M16A Engine Model); P/S Pump And A/C Compressor (If Equipped) Drive Belt Removal And Installation (J20A Engine Model); P/S Pump And A/C Compressor (If Equipped) Drive Belt Removal And Installation (F9Q Engine Model); Steering Rack Boot Check - Suzuki Grand Vitara 2011 Manual

6C-11 Power Assisted Steering System:
P/S Pump and A/C Compressor (If Equipped)
Drive Belt Removal and Installation (M16A
Engine Model)
Removal
1) Remove tension pulley bolt (1) and nut (2).
2) Remove tension pulley (3) and P/S pump drive belt
(4).
3
2
Installation
Reverse removal procedure noting the following
instruction.
Adjust belt tension referring to "P/S Pump and A/C
Compressor (If Equipped) Drive Belt Inspection and
Adjustment (M16A Engine Model)".
P/S Pump and A/C Compressor (If Equipped)
Drive Belt Removal and Installation (J20A
Engine Model)
Refer to "Water Pump and Generator Drive Belt
Removal and Installation (For J20 Engine): For Petrol
Engine Model in Section 1J".
P/S Pump and A/C Compressor (If Equipped)
Drive Belt Removal and Installation (F9Q Engine
Model)
Refer to "Accessory Drive Belt and Idler Pulley Removal
and Installation: For Diesel Engine Model in Section 1J".

Steering Rack Boot Check

• Check boot for crack and damage which, if any,
means possibility of rusty gear, entry of dust or lack of
grease. Also, check if any of such faulty conditions
exists.
• Check steering rack boot for dent or breakage.
If there is a dent, keep boot in most compressed state
for some seconds to correct dent.
S6JB0A6306007
1
4
I5JB0A630015-01
S6JB0A6306008
S6JB0A6306027
S6JB0A6306009
IYSQ01630013-01

Tie-Rod End Boot Check

Check boot for crack and damage and if any, replace it
with a new one.

Tie-Rod End Removal and Installation

Removal
1) Hoist vehicle and remove wheel.
2) Remove tie-rod end nut (3).
1. Tie-rod end
3) Disconnect tie-rod end (1) by using puller (2).
S6JB0A6306010
IYSQ01630014-01
S6JB0A6306011
IYSQ01630015-01
2. Knuckle
IYSQ01630016-01