GE ApexPro Service Manual page 86

3-30
Installation: ptsconfig Modify Receiver Command
The modify receiver command allows:
‹
segmenting of receiver/antenna systems, and specific assignment of care
units to those systems.
‹
a specific number of receivers to be assigned to specific care units. This
explicitly dictates exactly which receiver racks, and how many receivers in
those racks, can be assigned to a given care unit.
‹
configuration to allow specific care units access to unassigned receivers
With this setting enabled (Y), the specified care unit can use any number of
available receivers in the specified receiver rack, regardless of how many
receivers have been explicitly assigned to that care unit.
When using the modify receiver command, all other care units that could utilize the
remaining unassigned receivers in a rack should be added to the receiver list (modify
receiver command). If this is not done, available unassigned receivers will not be
used.
For example, a receiver rack containing 16 receivers is configured with 4 receivers
explicitly assigned to the 3Floor care unit. The unassigned receivers setting is
enabled (Y) for the 3Floor care unit. In this configuration, the 3Floor care unit can
use all 16 receivers available in the rack.
If other care units need access to unassigned receivers in the rack, those care units
must also be added to the receiver list, explicitly assigned a certain number of
receivers, and configured to either use, or be restricted from using, unassigned
receivers (Use unassigned receivers? Y/N>).
1. If necessary, start the PTSCONFIG utility according to instructions in
PTSCONFIG Utility"
2. Type modify receiver and press Enter.
3. Press Ctrl +] to exit out of ptsconfig then close the MS–DOS window by typing
exit at the prompt.
ApexPro Telemetry Server
2001989-178
on page 2-35.
"ApexPro
Revision C