Removing The Developing Assembly; Preparation; Procedure - Canon imageRUNNER 1750 Series Service Manual

4
Disassembly/Assembly > Image Formation System > Removing the Developing Assembly > Procedure
1) Open the Right Door Unit [1], release the Developing Pressure Lock Lever [2].
2) Release the Drum Cartridge Lock Lever [3], and then remove the Drum Cartridge [4].
[4]
[2]
4 Disassembly/Assembly > Image Formation System > Removing the Developing Assembly > Procedure
[1]
[3]

Removing the Developing Assembly

■ Preparation

1) Remove the Waste Toner Container.(Refer to page 4-67)
2) Remove the Drum Unit.(Refer to page 4-68)

■ Procedure

CAUTION:
• Place paper [1], and then place the Developing Assembly.
• Be sure not to tilt the Developing Assembly to prevent toner from spilling from the
Toner Duct [2] when disassembling/assembling
F-4-128
4-69
[2]
[1]
F-4-129
4-69