6.8.2
Wiring front connectors for I/O modules without shield contact element
Requirement
● The I/O modules are installed on the mounting rail.
● The supply voltages are turned off.
● The wires are prepared according to the utilized clamping technology, take the wiring
Tools required
● Stripping tool
● 3 to 3.5 mm screwdriver
Preparing and wiring front connectors for I/O modules without shield contact element
Proceed as follows to wire the front connector:
1. As needed, switch off the load power supply.
2. Place the included cable strain relief (cable tie) for the cable harness into the front
3. Swing the front cover of the wired I/O module up until the front cover latches (Figure 2).
S7-1500 Automation System
System Manual, 02/2014, A5E03461182-AB
rules (Page 65) into account for this purpose.
connector (Figure 1).
6.8 Front connector for the I/O modules
Wiring
73