Table of Contents
Advertisement
6
About IP2450 Appliance ADP Services Modules
ADP module type
Gigabit Ethernet SFP
10 Gigabit Ethernet XFP
For information about how to identify short-range and long-range ADP transceivers, see
install or remove ADP transceivers in a Check Point ADP module"
transceivers are hot swappable.
Note
Check Point supports only ADP modules and ADP transceivers sold by Check Point. For
further information, contact your Check Point representative.
Note
For IP2450 appliances, you need to install Check Point IPSO 6.x or later to use ADP
modules.
Installing and Replacing ADP Modules
Note
Before you begin this procedure, you should review all ADP module information in the
Getting Started Guide and Release Notes for the version of Check Point IPSO you are
using.
Use these instructions to install an ADP module in your appliance.
Before You Begin
To install a Check Point ADP module, you need the following:
A Phillips-head screwdriver
Physical access to the appliance
Access to the appliance by using Check Point Network Voyager or the CLI
A suitable, grounded work surface
The ADP module kit
70
Number of ports
Supported speeds
12
1000 Mbps
3
10 Gbps
Check Point IP2450 Security Platform Installation Guide
Supported ADP transceivers
• Fiber-optic (short range)
• Fiber-optic (long range)
• Copper
• Fiber-optic (short range)
• Fiber-optic (long range)
on page 74. The ADP
"To
Advertisement
Table of Contents
