Table of Contents
Advertisement
2
Installing the Check Point IP2450
Appliance
This chapter describes how to install the Check Point IP2450 appliance. The following topics are
discussed:
Rack Mounting the Appliance
Before You Begin
Caution
To help guard against electrostatic discharge damage, make sure you are properly
grounded by using a grounding wrist strap and following the instructions provided with
the wrist strap before you handle the components or open the appliance. The
grounding plug on the front of the appliance (shown in
chassis grounding point If you do not have a grounding wrist strap, make sure you are
properly grounded before you touch any electronic component.
Rack Mounting the Appliance
The Check Point IP2450 appliance mounts in a standard 19-inch equipment rack with four
mounting screws, as
appliance shipment.
Note
To avoid damaging your equipment, Check Point recommends that you use all four front
rack-mounting bolts when you install your appliance on the rack.
Check Point IP2450 Security Platform Installation Guide
Figure 8
shows. Optional rear-mounting brackets are included with your
Figure 1
on page 17) provides a
29
Advertisement
Table of Contents
