Storing System Logs On The Flash-Memory Pc Card; Disabling Flash-Memory Pc Cards - Nokia Check Point IP2450 Installation Manual

To remove a PC card in an IP2450
1. Perform a system shutdown by using Check Point Network Voyager or the CLI halt
command.
2. Press the eject button to remove the PC card.
Caution
To prevent the card from ejecting too quickly, hold the PC card while you push the eject
button.
3. Reboot the appliance.

Storing System Logs on the Flash-Memory PC Card

You can use the flash-memory PC card to store system log messages. Use Check Point Network
Voyager to configure the flash-memory PC card as an optional disk. After you reboot the Check
Point IP2450 appliance, use Check Point Network Voyager to configure system logging options.
For more information, see the Check Point Network Voyager documentation or online help.

Disabling Flash-Memory PC Cards

If you configure the flash-memory PC card as an optional disk, you must disable the card before
you remove it. You can disable the card by using Check Point Network Voyager or the CLI.
To use Check Point Network Voyager to disable a flash-memory PC card
1. Click System Logging under System Configuration and check the Unselect check box.
2. Click Apply.
3. Click Up.
4. Click Optional Disks under System Configuration and click the Off radio button under Local
Logging.
5. Click Apply.
6. Click Save.
7. Click Up.
8. Click Reboot, Shut Down System to shut down or reboot the appliance.
You can now remove the flash-memory PC card.
To use the CLI to disable a flash-memory PC card
1. Enter the following command:
set syslog local-log off
Check Point IP2450 Security Platform Installation Guide
Installing a PC Card
101