Advertisement
6. Open the left hatch and remove the left side cover
on the product.
7. Start the product. Refer to
275, DXR 305, DXR 315) on page 53 .
8. Put a magnet on the bottom side of the radio
communication receiver on the magnet symbol (D) in
5s after the start of the product. The indicator (E) on
the radio communication receiver flashes orange
quickly when it waits for a pairing operation to start.
E
D
Note:
It is necessary to put the magnet on the
magnet symbol in 5s after the start of the product.
After 5s the radio communication receiver cannot do
the pairing operation
9. Remove the magnet.
10. A serial number shows on the information center
display when a radio communication receiver is
found.
11. Make sure that the serial number on the information
display agrees with the serial number on the radio
communicator receiver.
12. If the serial numbers do not agree, the pairing
operation was not done correctly. Do the procedure
that follows.
a) Find the product with the agreed serial number
and turn that product off.
b) Stop your product. Refer to
(DXR 275, DXR 305, DXR 315) on page 62 .
c) Do the pairing operation procedure again.
58
To start the product (DXR
To stop the product
13. Push the right side button when the serial numbers
agree. A message on the information center display
will show for 2 seconds that the pairing operation is
done.
14. Stop the product to restart the radio communication
To stop the product (DXR 275,
receiver. Refer to
DXR 305, DXR 315) on page 62 .
15. Restart the remote control. Refer to
remote control on page 54 .
16. Start the product. Refer to
275, DXR 305, DXR 315) on page 53 .
17. Make sure that there is a radio signal symbol in the
information center display. Refer to
center display on page 51 .
18. Install the left side cover and close the left hatch on
the product.
To operate the product with the remote
control connected with a CAN bus
cable
WARNING:
control connected with a CAN bus cable
where there is a risk that the product can
fall.
The radio signal transmission stops when the remote
control is connected with the CAN bus cable.
•
Connect the CAN bus cable between the remote
control and the product. Refer to
remote control to the product with a CAN bus cable
(DXR 145) on page 59 and To connect the remote
control to the product with a CAN bus cable (DXR
275, DXR 305, DXR 315) on page 59 .
To start the
To start the product (DXR
Information
Do not use the remote
To connect the
1401 - 002 - 15.10.2021
Advertisement
