Advertisement
hydraulic system and electronic components can be
damaged.
•
Do not operate the product with tools and use lower
speed, if the hydraulic oil temperature is less than
10°C/50°F. Refer to
on page 30 .
•
Use the product in altitudes lower than 1000 m. If it
is necessary to operate the product in altitudes
higher than 1000 m, speak to your Husqvarna
service agent.
Personal protective equipment
WARNING:
instructions that follow before you use the
product.
•
Always use correct personal protective equipment
when you operate the product. The personal
protective equipment does not erase the risk of
injury. The personal protective equipment decreases
the grade of injury if an accident occurs. Let your
dealer help you select the right equipment.
•
Use approved eye protection while you operate the
product.
•
Use heavy duty clothing that is not loose but lets you
move freely.
•
Use approved protective gloves that enables a solid
hold.
•
Use an approved protective helmet.
•
Always use approved hearing protection while you
operate the product. Noise for a long period can
cause noise-induced hearing loss.
•
The product can cause dust and fumes that contain
dangerous chemicals. Use an approved respiratory
protection.
•
Do not let chemicals such as cleaning agent, grease
and hydraulic oil touch the skin.
•
Put on approval fall protection system when you
operate the product in locations where there is a fall
risk.
•
Use boots with steel toe-caps and non-slip soles.
•
Make sure that you have a first aid kit near.
•
Sparks can occur when you operate the product.
Make sure that you have a fire extinguisher near.
Work area safety
WARNING:
no persons, children or animals in the work
area. If a person or animal enters the area,
immediately stop the product.
•
Look out for bystanders, objects and situations that
can prevent safe operation of the product.
•
During operation, no person is permitted in the work
area (X) and (Y) shown in the illustration. This
applies to bystanders and the operator. The area (X)
20
To let the product become warm
Read the warning
Make sure that there are
is the range of the product. Refer to
dimensions on page 117 .
Different work methods, work objects, tools and
surfaces can change the dimension of the work area
(Y). Look for possible risks before you operate the
product. Change the work area if the conditions
change during operation.
Y
X
•
Cordon off the work area.
•
Increase the work area when you do work at a
height. Cordon off the risk area at ground level.
Make sure that no materials can fall down and cause
injury.
•
Keep the work area sufficiently illuminated.
•
The product can be operated by a remote control for
long distances. Do not operate the product unless
you have clear view of the product and its risk area.
Use a camera system if the view is not sufficient.
•
Clear the work area of obstacles.
•
Be careful when there is a risk of slippery surfaces.
•
Do a check of the ground conditions and the support
structures to make sure that materials, equipment
and bystanders cannot fall.
•
Do not use the product in areas where fire or
explosions can occur.
•
Make sure that no pipelines or electrical cables are
in the material to be cut. Make marks where the
pipelines and electrical cables are in the work area.
•
Make sure that there is no flow in the pipelines in the
work area. Make sure that the electrical cables in the
work area are disconnected. The product must not
come near power lines in the air.
Electrical safety
WARNING:
shocks from electrical products. Do not use
the product in bad weather conditions, for
example, heavy fog or rain, strong wind and
sand storm. Always use the product as
Range
X
Y
There is always a risk of
1401 - 002 - 15.10.2021
Advertisement
