Husqvarna DXR 145 Operator's Manual page 33

12. Install the locking pin into the wedge. Put the locking
pin in the hole that is nearest the tool.
13. Connect the hoses from the tool to the product. Do
the procedure that follows. The tool is seen from the
rear side.
a) Connect the return hose (D) to the A port (E) on
the right side of the product.
E
D
1401 - 002 - 15.10.2021
b) Connect the pressure hose (F) to the B port (G)
on the left side of the product.
c) For DXR 305 and the breaker: Connect the
return hose (H) to the A port (E) on the right side
of the product.
E
H
14. Remove the tool in the opposite sequence.
Accessory packs
Different accessory packs are available to prevent
damage to the product and to expand the work area of
the product. Refer to the table below. The accessory
packs can be installed from factory or can be installed
on the product. If the accessory packs are not installed
from factory, let an approved Husqvarna service agent
install the accessory packs.
G
F
33