en
Faults and what to do about them
Faults
Fluff found on the
laundry.
Water inlet noise
during the drying
phase.
Drying duration
extended.
Drying programme
does not start.
Creasing.
48
Cause/Remedy
Run the Drum Clean — (cold) programme without laundry and
detergent to remove fluff which have accumulated inside the
drum during the previous drying cycle.
The washer dryer uses water condensation technology, water is
constantly needed to dry the laundry. Therefore the water tap
must be on all the time, till the end of the drying phase.
Run the Drum Clean — (cold) programme to remove fluff
■
which has collected in the washer drum during the drying
phase.
If the ambient temperature is higher than 30 °C, this may
■
extend the drying time.
Insufficient air circulation in the room may increase the dry-
■
ing time. Ventilate the room.
Drying additional programme setting not selected?
■
Door not closed properly?
■
Creasing occurs when you have exceeded the maximum
■
load or selected the wrong program for the type of fabric. All
the required information can be found in the programme
overview table.
Remove clothes immediately after drying; creasing may
■
occur if they are left in the drum.