Table of Contents
Advertisement
en
Operating the appliance
Adding/removing laundry
After starting the programme, you can
add or remove laundry if necessary.
Touch the A Start/Pause button. The
appliance checks whether reloading is
possible.
If the following appears on the display
panel:
The symbol Õ disappears, reloading
■
is possible.
The symbol Õ lights up, reloading is
■
not possible.
To continue the programme, touch
the A Start/Pause button. The
programme continues automatically.
Notes
Do not leave the door open for too
■
long when adding laundry as water
from the laundry may leak out.
For safety reasons, the door remains
■
locked when the water level or
temperature is high, or while the
drum is turning, and it is not possible
to add laundry during this time.
Changing the programme
If you have started the wrong
programme by mistake, you can change
the programme as follows:
1.
Touch the A Start/Pause button.
Select another programme.
2.
3.
And touch the A Start/Pause
button again. The new programme
starts from the beginning.
Note:
If drying is activated, you have to
switch the appliance off and on again to
change the drying programme.
Cancel the programme
For programmes washing at high
temperatures:
1.
Touch the A Start/Pause button.
To cool down laundry: Select Rinse .
2.
3.
Touch the A Start/Pause button.
38
For programmes washing at low
temperatures:
1.
Touch the A Start/Pause button.
Select Spin .
2.
3.
Touch the A Start/Pause button.
For programmes in drying process:
1.
Touch the A Start/Pause button.
If the Hot on the display panel,
2.
waiting for the appliance running to
cool down the laundry till the Hot
disappears.
Programme end
End lights up on the display and ~ and
Õ displays are off.
If you have selected 2, the water is only
drained after rinse process, no spin cycle.
Notes
If Hot flashes in the display before
■
the drying programme ends, the
temperature in the drum is high. The
programme for cooling the drum runs
until the temperature in the drum has
dropped.
If you do not take laundry out within
■
15 mins after drying process finished,
wrinkle guard process will start to
prevent laundry getting wrinkled. The
process lasts about 30 minutes. 0:00,
£'˜, £© and "Ÿš will be displayed
alternately on the display and V
symbol will be displayed as the status
symbol. You can touch any button to
terminate this process, then the door
will be released and laundry can be
taken out.
Removing laundry/
switching off the appliance
1.
Set programme selector to Off.
Open the door and remove the
2.
laundry.
Turn off the water tap.
3.
Note:
Not required for Aqua-Stop
models.
Advertisement
Table of Contents
