Table of Contents
Advertisement
0
Programme default
settings
Y ou can change the default settings for
P r o g r a m m e d e f a u l t s e t t i n g s
selected programmes. The settings can
be changed even while the selected
programme is running. The effects
depending on the progress of the
programme.
6 Temp.°C
Before and after the programme starts,
you can change the temperature setting,
depending on what stage the programme
is in, by adjusting the desired
temperature on the display.
The maximum temperature that can be
set depends on the programme that has
been selected.
0 Spin Speed
Depending on what stage the programme
is in, you can change the spin speed (in
rpm; revolutions per minute) before and
during the programme by adjusting the
desired speed on the display.
setting 2: 2 ="No spin". The rinsing
water is drained but there is no final spin.
The laundry stays wet inside the drum,
e.g. for items that should not be spun.
You can select "No spin" to prevent
creasing if the laundry will not be taken
out of the appliance immediately after
the programme has ended.
The maximum speed that can be set
depending on the model and the
programme that has been selected.
Programme default settings
ñ Ready in
Before starting the programme, you
can preselect the programme end ("Finish
in" time) in 0.5h (h = hour) increments
(between "minimum selectable ending
time" and 9.5h) or 1 hour increments
(between 10h and 24h) up to a maximum
of 24 hours.
To do this:
1.
Select a programme (except
myTime
*
programme).
The programme duration is displayed
for the selected programme, e.g.
2:30 (hours:minutes).
Select the ñ Ready in button
2.
repeatedly until the required number
of hours is displayed.
Select the A Start/Pause button.
3.
The programme starts.
The selected number of hours (e.g.
8h) is shown in the display panel and
counts down until the programme
starts. The duration of the programme
is then displayed.
Note:
The length of the programme is
automatically adjusted when the
programme is running. Changes to the
programme default settings or additional
programme settings may also change the
programme duration.
After starting the programme (if a
"Finish in" time has been selected and
the programme has not yet started), you
can change the preselected number of
hours as follows:
1.
Select the A Start/Pause button.
Select the ñ Ready in button
2.
repeatedly to change the number of
hours.
Select the A Start/Pause button.
3.
* Depending on the model
en
33
Advertisement
Table of Contents
