Setting time zone
Time Zone menu is enable only when monitor is not connected to
network and discharge paitent/haven't admitted patient.
Monitor Setup
1. Press
key.
2. Select Install/Service and enter the password.
3. Select Time Zone
•
Daylight Saving: to turn on, turn off or set auto adjust
daylight savings time (DST).
•
DST Offset Hour: to set the hours offset for daylight savings.
•
DST Offset Minute: to set the minutes offset for daylight
savings.
•
DST Begins: to set daylight savings begin time.
•
DST Ends: to set daylight savings end time.
•
Time Sync: to set time sync options, Unity is time sync to
Unity Network, NTP is time sync to NTP Server.
•
NTP Config: to set NTP Server configuration.
- GMT Offset Hours: to set offset hours from GMT
(Greenwich Mean Time).
- GMT Offset Minutes: to set offset minutes from GMT.
- Primary Server IP: to set primary NTP Server IP address.
- Secondary Serv IP: to set secondary NTP Server IP address.
36
NOTES:
−
DST Offset Hour and DST Offset Minute menu are enable
only when the Daylight Saving is set to ON or AUTO.
−
DST Begins and DST Ends menu are enable only when the
Daylight Saving is set to AUTO.
−
Time Sync menu is shown only when monitor configuration
is Unity+HL7.
−
NTP Config menu is shown only when monitor configuration
is Unity+HL7 or HL7. NTP Config menu is enable only when
Time Sync is set to NTP.