Bosch ADS-AMC2-4R4CF Installation Manual page 52

52 en | Appendices
–
–
Push
0
1
2
3
4
5
5a
5b
5c
6
7
8
9
10
11
12
13
2022-03 | V03 |
If the network is operating with a DHCP server, the AMC will get its network configuration
automatically from the DHCP server.
If the network is operating without a DHCP server, the link-local address will remain
active until otherwise configured via the AMCIPConfig tool.
Display (Example)
AMC-xxxxx
Vxx.xx xx.xx.xx
S/N1: 0910024419
S/N2: 22850034
11.18 12:24:18 S
Dig. IO: ::::::::::::::::
(only available with
Dig. I1: ::::::::::::::::
Dig. I2: ::::::::::::::::
Dig. I3: ::::::::::::::::
MAC 001B860012AB
N AMC-1234-5678
I 192.168.10.18
G 192.168.10.255
M 255.255.255.0
H 192.168.10.10
DHCP 1
D 192.168.10.1
Description
Display firmware variants:
- Bootloader
- WIEGAND
- LBUS
- OSDP
- BG900
aa = Reader Protocol Version
37 - Wiegand, 60 - Lbus, 61 - BG900, 62 - OSDP
bb = Firmware Version
01.05.17 release date of the firmware (dd.mm.yy)
Serial number 18 digits - Part1 10 digits
Part 2 - 8 digits
Current date and time (MM.DD hh:mm:ss)
(S) = daylight saving
Display of the digital contacts: the input signals set will
be shown with an extension above - output signals with
an extension below. The first eight digits display the
controller's signals. The second eight digits display the
extension board's signals.
(Not available for Bootloader FW)
If there are I/O-Boards connected, the signals will be
shown on separate pages. (Not available for Bootloader
FW)
Network device address (MAC)
Network name of the controller (max. 14 char.)
See Configuring Ethernet interface, page 34 .
IP-address of the controller
IP-address of the gateway
Subnetmask
IP-address of the host computer
DHCP-status:
1 = on
0 = off
IP-address of the DNS server
Installation manual
Access Modular Controller 2
Bosch Security Systems B.V.